Worm Drive Circular Saw Dust Collection
Item # D4000
Some people buy a saw just for the included shroud. Don’t buy a new one—use the saws you already have. If you rely on one saw or many, you don’t have to worry about buying a new grinder for dust containment.
The DustBuddie is meant to fit most 7 1/4” worm drive and hypoid circular saws and will adapt to most standard wet dry vacuums.
|Port Size||1.25", 1.5"|
Dust shields capture dust at the front and back
ABS/Polycarbonate Blend for abrasion resistance
Adapts to 1.25" and 1.5" hoses
Included With This Product:
- (1) DustBuddie for Worm Drive Saws
- (1) 1.5” x 1.5” Adapter Cuff
- (1) Front Rubber Dust Shield
- (1) Rear Rubber Dust Shield (Optional)
- (1) Releaseable Tie
"4.5 stars for performance, design, quality and value."
"In the past…I would have dust all over, my clothes would be trashed… Not today!"
- John Rugg
Installation and Setup
1. Place saw on the DustBuddie
2. Secure with two hook-and-loop straps
3. Hook up your dust shroud to your vacuum
Proposition 65 Warning for California Residents
WARNING: This product can expose you to chemicals including acrylonitrile, which is known to the State of California to cause cancer, and isopropylidenediphenol (BPA) which is known to the state of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.