5" DustBuddie XP w/ 18" Hose
Grinding Shroud for Angle Grinders
Item # D5835
Some people buy a grinder just for the included shroud. Don’t buy a new one—use the grinders you already have.
The DustBuddie is meant to fit most 4-5” grinders. If you know the collar diameter of your grinder, the DustBuddie will fit collars between 1.3” and 2.1”.
Click here for help in determining if your grinder is compatible with this shroud.
|Hose Length||1.50 ft|
Sliding edge for grinding against walls
Brush skirt bottom creates seal
Compliant with OSHA & EPA Laws
Included With This Product:
- (1) 5” DustBuddie XP
- (1) 18” Adapter Hose
- (3) Spacing Washers
- (1) Releasable Tie
"I was working on a concrete slab while LIVING in the house...This worked flawlessly."
- Amanda H.
"Amazingly little dust. Used in a basement and didn’t even need a dust mask."
- Pointe Lumber
Installation and Setup
1. Tighten the DustBuddie around grinder collar
2. Install appropriate grinding wheel
3. Attach the dust shroud to your vacuum
Proposition 65 Warning for California Residents
WARNING: This product can expose you to chemicals including glass wool, which is known to the State of California to cause cancer, and hexavalent chromium which is known to the state of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.